I have always loved sitting on my dock and watching the incredible boats idle by in close proximity but something just feels even better about it now.
Last Post By: Instigator Today, 05:04 AMHi,
I have a new to me 1990 Yamaha 115 2-stroke carb motor. It idles fine and runs good up to about 2200 rpm, then starts bucking and jerking.
I have twin 300 promaxs 26ft American offshore.. 25ft talon bottom.. 18inch box's and 1.62 sportmasters even with bottom of sponsons..have 3/16 toe out
Last Post By: 99fxst99 Yesterday, 11:36 PMI am familiar with the late 90s 250 EFI as they are the same engine up to 2001 with the “digital” injection…then in 02 it’s still an EFI “non optimax”
Last Post By: Aaronhl Yesterday, 10:28 PMI bought this engine 1 year ago. it didn’t have thermostats or a popit valve in it when I bought it so put all new back in and it throws the overheat
Last Post By: Baker343 Yesterday, 10:20 PMLooking for advice, done some googling and searching on S&F, this has been touched on but have not come across definitive info..
Using
Gents all input is welcome and encouraged. This is my first Merc build so I'll need guidance here. I dont have a manual for this motor im running on instinct
Last Post By: LakeFever Yesterday, 08:58 PMThis World is in their past now ... peace be you with ...
Have an early (1998/1999ish) pair of RH & LH sportmasters. There are no numbers on them other than 619# on the port side lower. Keyways have corroded
Last Post By: prosedonzi Yesterday, 07:50 PMlooks like another scammer.
Original 23' outboard, 8' Beam, 2018 Mercury 400 on stainless marine setback.
20" lower with fat shaft
Boat has small cabin,
Have had these RH and LH Sportmaster lowers since 2006 as spares for my 300X's. Boat has been sold. I had a local mechanic go through them and replace
Last Post By: cougarcat Yesterday, 03:39 PMSelling a used Mercury Racing Bravo XS 24.5 pitch 4 RH SS propeller. The prop have never been worked on. There are a few minor dings on the edges of blades.
Last Post By: rgoss66892@aol.com Yesterday, 03:14 PMre-rigged my ride with a 2.5, single piston trim clamp; hooked my existing lines[same remote pump] which works fine, but motor wont trim. i cracked the
Last Post By: KIRCHNER Yesterday, 01:44 PM
Missing Talon
Thread Starter: 99fxst99Trying to find my old Talon T18. Been sold a couple of times since I (regrettably) sold it, and I lost track of it. Would like to know where it is and
Last Post By: mikesufka Today, 05:18 AM